1-1/2 PIPE EXTNDR OD X ID SPIG

🔧 1-1/2" PVC Pipe Extender (Outside Diameter × Inside Diameter Spigot)

It’s a plumbing repair fitting used to extend or reconnect existing drain pipe without major pipe replacement.

⚙️ Breaking down the code

• 1-1/2 → fits 1-1/2" pipe systems
• PIPE EXTNDR → pipe extender / repair extender fitting
• OD X ID → connects using both outside diameter and inside diameter sizing
• SPIG → spigot end (same OD as pipe, fits into a hub/fitting)

🔧 What it does

This fitting is used to:

• Extend a pipe stub that’s too short
• Repair cut or damaged drain lines
• Reconnect existing plumbing in tight spaces
• Adapt between hub/socket and inside pipe connections

🏠 Where it’s used

Most commonly in:

• DWV plumbing (drain/waste/vent)
• Sink drains
• Tub/shower drains
• Trap arm repairs
• Remodel plumbing work

🧰 How it works

A pipe extender usually:

• Slides into an existing pipe or fitting
• Provides a new section of usable pipe length
• Is solvent welded (PVC cement/primer)

The spigot end acts like pipe, not a fitting hub.

🧠 Simple explanation

It’s basically a repair adapter that gives you extra pipe length when an existing drain pipe is too short to reconnect properly.

⚠️ Important note

• Commonly PVC or ABS depending on plumbing system
• Must match:
  • pipe material,
  • schedule,
  • and DWV sizing
• “OD × ID” repair fittings are often used specifically for remodel/service plumbing where standard couplings won’t fit